Home > Resin > WIP Flash Curing Resin Printed Objects.

WIP Flash Curing Resin Printed Objects.

January 13th, 2013 Leave a comment Go to comments

Happy New Year to ALL!

Long time no updates.  Guilty, but, BUT Here is a WIP Flash curing hardening of the resin printed objects:

 

Cheers!

 

Categories: Resin Tags:
  1. elite3d
    January 21st, 2013 at 04:17 | #1
    Reply | Quote

    Hi,

    I would like to say that after spending all weekend reading through all of the information on your project that it was very educating and very well done. I just have one question on the standoff’s for the lens. Are you increasing the space between the lens and the image processor or are you decreasing it. Any help would be greatly appericated and if not i understand.

    Thanks,

    Elite3D

    • Printer
      January 25th, 2013 at 23:50 | #2
      Reply | Quote

      Hi Elite3D,
      With the standoffs I’m increasing the distance between the DLP chip and the lens assembly – therefore reducing the size of the projected image out of the lens.
      and sometimes you need to remove the limit screw from the lens assembly to be able to have greater focal control.

      Ask away anything.

      Cheers
      Peter

      P.S. Good Luck with your build!

  2. elite3d
    January 26th, 2013 at 03:22 | #3
    Reply | Quote

    Hi Peter,

    Thank you for answering my question. I apperciate it very much.I’ll keep you informed with my build.

    Thanks for the invite to your blog and community

    Take care,

    Elite3D

  1. No trackbacks yet.