Archive for the ‘Build Base’ Category

New Video – 4 rings

February 19th, 2012 14 comments

New video of the 4 rings platform:

4 Rings – Last night’s Platform…

February 19th, 2012 5 comments

Last night I decided to test the printer with some new resin I got from Fernando @

Here are some photos and I have added them in the “Gallery” Section above.

New and Improved Build Base

February 8th, 2012 4 comments

We start today’s post with an update – repairing the damage done by the “Force”. I have decided to make it out of Plexiglas or Perspex. I have contacted a local sign/advertizing company willing to cut it out for me and it was ready in a couple of days and in front of my door. I chose to use 10mm clear plexi since it was standard and readily available. I could have asked for a “black-matte”, but it would have delayed the order.

Measurements are:

10mm X 60mm X 70mm

10mm X 70mm X 90mm


and I added 8mm holes with 15mm countersinks for M8 X30 bolt head that are 6mm deep  with a spacing measured off the Bracket ( Click Here ) in My case 26mm.

I have cut 3 sets should I need to make one fast ;-)

I had tested  JB Weld-Regular with some of the cutout pieces of Plexi. Seems to hold up the Plexi to Plexi. What I was concerned about was the Plexi to Glass.

You can use some 200 sandpaper to rough the glass and plexi mating surfaces and clean them with Aethanol or Isopropyl Alcohol 96% and some no-lint cloth.

After inserting the bolts and spreading a generous amount of JBWeld ( you can clean it up the oozing after it sets for a few hours ).

Follow the instructions for using JB Weld – I placed it in a warm room @25C. Keep the base on a level surface – glass down, as the JB has not set yet. You can use regular tape to keep the two from sliding.

Result is this:


I have tested it with the same resin ( say ~1300 cP@25 )and it seems to hold up very well for now.

This is Life – I hope to not have to  redo it AGAIN?! ;-)




Categories: Build Base Tags: , ,