Archive

Archive for the ‘X-Motion’ Category

3D Printer DLP Printing with UV resin…

December 24th, 2011 11 comments

What can I say? The title pretty much gave it away…

It’s an early Christmas Present…

Questions will be partially answered after 27th and fully after New Years!

Itching to publish!

November 29th, 2011 6 comments

Here it is! The VAT Tilt test X-axis. Did only a few layers, but watch the VAT tilting:

Good Night for me and Good Morning to the other side of the planet!

Categories: VAT, X-Motion Tags: , , ,

VAT-Tilt connection

November 29th, 2011 No comments

It is one of the least, but not last thing left to do. The VAT to Tilt to X axis connection.

This is going to be long. Time me if you want. Start:

Mark 7mm from each sideĀ  ( you can pick another number as long as it is a sacred one ).
Drill with M4 bit and a vacuum cleaner at this point to avoid getting chips in unwanted places and shortening something.

Assembled an L shape bracket with a bolt like so:

Cut 2 x M4 threaded rod pieces in 125mm lengths:

Assemble the rods and L shape into:

Bend the rods to be perpendicular to the Meccano piece:

Now attach the Meccano piece with some M5 Inbus:

I had to recenter my X- axis to be in the center of the rods.

Finally bolt together, tighten and adjust with top lock nuts.

 

Stop!
Phew! That was a fast one. Took me longer to stop and take photos, than to actually assemble.

Yamas!

 

Categories: VAT, X-Motion Tags: , , ,